Graphene mesosponge outperforms carbon nanotubes as a conductive additive in high-loading Li-ion cathodes
Researchers at Yokohama National University, Yonsei University and 3DC have shown that graphene mesosponge (GMS), a three-dimensional, sponge-like graphene material, can improve ion transport in dense, high-loading lithium-ion battery cathodes. In their tests, an electrode containing just 1 wt.% GMS outperformed one with single-walled carbon nanotubes (SWCNTs), a conductive additive used in commercial cells, at high discharge rates.
Graphene mesosponge (GMS), with its unique mesoporous architecture, facilitates three-dimensional electron and ion transport in high-loading, densely packed lithium-ion-battery electrodes. Its three-dimensionally interconnected carbon framework provides efficient electronic conduction, while electrolyte accommodated within the GMS mesopores promotes ionic transport, thereby enabling excellent rate performance under practical electrode conditions at high current densities. Image credit: YOKOHAMA National University, from Eurekalert
Raising a battery’s energy density means packing in more active material and then compressing the electrode by roll pressing. That squeezes out the pores that lithium ions travel through, which slows ion transport. The team says GMS addresses this because its mesopores take up electrolyte, forming ion pathways inside the carbon network, while the graphene framework carries the electrons. The material has a BET surface area of 936 m²/g, more than 20 times that of acetylene black (39 m²/g) and slightly below that of SWCNTs (1,225 m²/g).
The researchers tested cobalt-free, lithium-deficient LiNiO₂-type (Li₀.₉₇₅Ni₁.₀₂₅O₂) cathodes with an active-material loading of about 20 mg/cm², comparing 1 wt.% GMS with 0.5 wt.% SWCNTs after roll pressing to roughly 3.5 g/cm³. After pressing, the SWCNT electrode showed cracked active-material particles, while the GMS electrode did not, which the team attributes to the material’s softness. The GMS electrode had higher ionic conductivity, although its electronic conductivity was slightly lower, and it delivered higher energy density at current rates above about 400 mA/g (roughly 8 mA/cm²). That advantage did not appear in electrodes that had not been densified. In 3D tomography of the electrodes, the ion pathways were on average 12.1% thicker and 8.3% shorter in the GMS electrode.
The team noted some limitations of thier results. A lower content of 0.5 wt.% GMS gave insufficient capacity, the choice of binder matters because some binders block the pores, and cycling performance was similar to SWCNT at moderate current. The tests used lithium-metal cells with a concentrated electrolyte. The team says its goal is to combine the approach with a graphite negative electrode to achieve fast charging.
Earlier coverage: 3DC showcases new 3D graphene nanomaterial for batteries at CES 2026