A*STAR

A*STAR team uses graphene oxide to create a cathode for improved li-ion batteries

A*STAR researchers have found that incorporating organic materials into lithium ion batteries could lower their cost and make them more environmentally friendly. The team has developed an organic-based battery cathode that has significantly improved electrochemical performance compared to previous organic cathode materials. The new material is also robust, remaining stable over thousands of battery charge/discharge cycles.

An electron-deficient, rigid organic molecule called hexaazatrinaphthalene (HATN) was previously investigated as an organic cathode material for lithium ion batteries. However, its promising initial performance declined rapidly during use, because the molecule began to dissolve into the battery’s liquid electrolyte. A new cathode material, in which HATN was combined with graphene oxide in an attempt to prevent the organic material from dissolving, has now been developed by Yugen Zhang and his colleagues from the A*STAR Institute of Bioengineering and Nanotechnology.

Read the full story Posted: Aug 25,2018

Graphene oxide to enable ultrafast disposable humidity sensors

Researchers at A*STAR have designed a low-cost, stable and ultrafast graphene oxide-based responsive humidity sensor that is said to be easy to manufacture, overcoming the challenge of producing a simple, fast and highly sensitive version. The ability to monitor and control humidity levels using accurate and reliable sensors is essential for efficient manufacturing and storage practices as well as everyday life.

Unlike most humidity sensors, which are electronic and require a power supply, GO-based colorimetric sensors respond to humidity levels by changing color that can be easily observed. For greater accuracy, the change in color can be quantitatively measured by analyzing the reflection spectra of the sensor. Because the GO sensor operates at the atomic level, it can rapidly respond to moisture changes.

Read the full story Posted: Jul 31,2016

Graphene to improve the performance of computer hard drives

Researchers at A*STAR have found that graphene could be helpful in improving the performance of computer hard drives.

Hard drives store data by using magnetic fields to change the properties of a small section of a magnetically sensitive material. Decreasing the size of this section increases the drive’s capacity but also increases the size of the magnetic field required for switching. Furthermore, the minimum size of the magnetic field is limited by an effect known as superparamagnetism, in which the magnetic properties at the nanometer-scale can spontaneously change, losing any stored information. HAMR (heat-assisted magnetic recording) is a method that uses a laser beam to heat the storage medium to a temperature at which the magnetic field strength required for writing is lower and superparamagnetism is less prevalent.

Read the full story Posted: Jun 06,2016

Graphene to enable small and versatile X-ray source

A collaboration between the A*STAR Singapore Institute of Manufacturing Technology (SIMTech) and the Massachusetts Institute of Technology (MIT) in the United States has proposed a versatile, directional graphene-based X-ray source that potentially could fit on a laboratory bench.

An X-ray source that is both small and powerful is a highly desirable concept. The researchers wanted to create something that is compact and also capable of producing very intense X-rays, essentially implementing the concept behind the enormous free-electron-laser sources on a scale small enough to fit on a laboratory table or even a microchip. For this purpose, the team utilized graphene's ability to support plasmons — collections of electronic oscillations that can be used to confine and manipulate light on scales of around ten nanometers. The scientists explain that Graphene plasmons are a natural option because they are capable of confining electromagnetic radiation to very small scales.

Read the full story Posted: Apr 07,2016

Graphene and metal nitrides create improved asymmetric supercapacitors

Researchers at A*STAR have developed an 'asymmetric' supercapacitor based on vertically aligned graphene nanosheets coated with iron nitride and titanium nitride as the anode and cathode, that could be a viable energy storage solution.

While traditional supercapacitors use the same material for both electrodes, the anode and cathode in an asymmetric supercapacitor are made up of different materials. Scientists initially used metal oxides as asymmetric supercapacitor electrodes, but as metal oxides do not have particularly high electrical conductivity and become unstable over long operating cycles, it was clear that a better alternative was needed.

Read the full story Posted: Nov 19,2015 - 1 comment

Researchers say graphene will outperform ITO as solar panel transparent electrode material

Researchers from Singapore's A*STAR institute discovered that graphene outperforms ITO as solar panels transparent electrodes. The researchers say that stacking four graphene sheets is the best method - as more graphene sheets decrease the resistance but blocks more light.

A single graphene sheets blocks less than 3% of light which means more light can reach the solar panel. Graphene's efficiency as a solar panel electrode depends on the type of light absorbed by the panel. For solar panels that absorb near-infrared light graphene is only slightly less effective than ITO, while graphene would be ideally suited to photovoltaic cells with a very broad absorption range, such as a recently developed organic solar cell that can harvest light from 350 to 850 nanometers.

Read the full story Posted: Dec 19,2013

New GNR-based magnetic field-effect transistor

Researchers from Singapore's A*STAR Institute developed a new graphene ribbons (GNRs) based magnetic field-effect transistor (it responds to changes in a magnetic field).

The basic idea is to use two armchair-edged GNRs joined end to end. One of the ribbons acts as a metallic conductor while the other one (which is wider) acts as a semiconductor. The existence of a magnetic field makes this device conductive.

Read the full story Posted: Jul 18,2013

Graphene may have potentially adverse environmental and health risks

Sweden's Department of Energy and Environment studied the available information on graphene, and came up with the conclusion that the new material may have potentially adverse environmental and health risks. Graphene could exert a considerable toxicity and it is also suggested that graphene is both persistent and hydrophobic (graphene is a very effective water repellent).

There are still many risk-related knowledge gaps to be filled, according to the researchers as "Considerable" emissions of graphene from electronic devices and composites are possible in the future.

Read the full story Posted: May 12,2013

Graphene with Graphone domains can be used to pack molecules

Researchers from Singapore's A*STAR institute and the US have designed a new way to pack molecule using graphene and graphone (graphene that is hydrogenated on one side) structures. The idea is to use a graphene sheet with a graphone domain that can be used to trap molecules. This is achievable because the graphone region is distorted in 3D to form a cap shape and it is stable well above room temperature.

In the research they used fullerenes as model molecules. It turns out that you can trap several molecules in the same graphone domain. This kind of structure can be useful for energy storage or biological applications.

Read the full story Posted: Oct 10,2012

Graphene Oxide may be toxic, kills bacteria

Some scientists are concerned that Graphene may be hazardous and toxic - for humans, animals and the natural environment. Researchers from Singapore's A*STAR have published a study on how graphite, graphite oxide, graphene oxide and reduced graphene oxide may effect bacteria (Escherichia coli in the study).

The researchers showed that the graphene-based materials kill substantially more bacteria than graphite-based materials. Graphene Oxide was the most dangerous material. The researchers say that most of the E.coli cells were individually wrapped by layers of graphene oxide. In contrast, E. coli cells were usually embedded in the larger reduced-graphene-oxide aggregates (see image above).

Read the full story Posted: Sep 02,2012